Installation: Super/UV Plug-in

1. Install Super/UV Into Lightwave Modeler 7.5c
   • Extract the .p file.
   • Install it into Modeler like you would any other .p file.
2. Assign Buttons to Super/UV Commands
   • Assign buttons or keystrokes as you would with any Lightwave Plug-in to the following eight commands that ResPower Super/UV adds to Lightwave Modeler:
     • SUVPolySnap
     • SUVPolyMove
     • SUVPolyScale
     • SUVPolyRotate
     • SUVPolyStretch
     • SUVMapExport
     • SUVMapFit
     • SUVFitStretch
     • SUVAbout
     Example Procedure For Assigning Buttons
     1. Select Interface->Edit Menu Layout from the Ligthwave Modeler menu.
     2. In the "Configure Menus" dialog, expand "Additional" and scroll down until you see the Super/UV commands. They all start with "SUV", and the list is alphabetized. It is normal for them to be greyed out.
     3. On the right-hand side, expand Main Menu, and Select "Map". Click on the "New Group" button in the set of commands along the right-hand side of the dialog. Select the "New Group" that this creates inside of "Map" and click "Rename". Rename the group to Super/UV.
     4. Select the "Super/UV" group in the right-hand column and the first Super/UV command in the left hand column. Click "Add". This will add SUVMapExport to the "Super/UV" group on the Map tab.
     5. For each remaining Super/UV command, repeat the previous step.
     6. Click done, and marvel at your new-fangled Super/UV menu.